Hondaline 300 Info

[SYKO]

Pistons for this kit are no longer avalable from Honda. We have found a 76mm piston that will work with a cylinder modification.

Piston kit (piston, rings pin & clips) $149.95
Top end gasket set (head & base gasket)
Wrist pin bearing 14.95
Cylinder modification $75
Bore cylinder (if necessary) $60
Resleeve cylinder (if necessary) $250, includes the sleeve and it's installation.

Thank you for your inquiry,
Vance, Q&E, Inc.

----- Original Message -----
From: ALAN SIMMONS PDA/ SOUTHGACUSTOMS
To: Vance@qande.com
Sent: Sunday, December 10, 2006 8:40 AM
Subject: 83 hondaline 300



http://www.qande.com/

so now nobody can complain about not finding any parts for there motor

[250rBeast]

This is the guy here in Ca that I was referring to in your last post about selling the 300 gaskets. He uses a water cooled 330 piston and modifies the cylinder to make it work. Vance is a good guy, I've spoken to him and have been to his shop in Anaheim. Ridetrikes250R has had this done to his 83 by Vance. It's a bit costly but at least someone is willing to make those old air cooled big bore bikes run again.